Polypro Hoops

Your hoop arrives partially coiled and may look like 2 hoops. Please follow these important steps to properly uncoil your hoop.

• Clip off the zip-tie located across from the connection point. Do NOT unfold the hoop into a figure 8. Doing so will cause damage to the tubing that is not covered under warranty.
• There is a small piece of tubing over the ends to keep the hoop coiled down while in the box. Carefully slide off that piece of tubing.
• If there is a sticker over the snap button, remove it.
• Carefully uncoil your hoop, press down the snap button, and insert one end in to the other. Make sure the snap button pops up inside the hole after insertion.

Do not coil your polypro hoop all the way. Polypro is less flexible than HDPE and will crack if bent too far. Avoid extremely strong impacts against hard surfaces. Cold temperatures increase the brittleness.