Classic LED Wand

Find the power switch by locating the end with a sticker. The switch is located underneath the cap. Push down in the center of the cap to operate the switch.

Your wand comes with a default string attachment that measures 32 inches in length. The swivel is 2 inches above the top of the wand when upright. There is a split ring attached to the swivel that you can remove to play with the wand in traditional open loop style.

If you purchased the silicone contact caps, then your LED levi wand comes with a pack of washers. You can add any amount of washers to both the top and bottom caps to fine tune the balance of your wand. Simply push the washers all the way down into the cap.

On the opposite end from the power switch, remove the cap to locate the micro USB charging port. We recommend using the USB charger and cables supplied with your order, but you can safely use any working cable and charger. While charging, you will see a red light on inside the prop. When charging is finished, the red light will turn off.

For best possible battery health:
• Do not leave your lights on while charging.
• Do not leave your lights in a completely discharged state.
• Do not expose to hot temperatures (for example, leaving them in a car with the windows up in the middle of the summer).